My original goal for developing the pantorouter was to build a machine that would cut tenons that are trimmed on all sides, including rounding both ends to perfectly fit the rounded slot mortises from a slot mortiser such as my homemade slot mortiser The best way to produce tenons with rounded edges would be to cut them with a router. Es muy difícil recuperar el filo original mediante el afilado casero, pero podemos aproximarnos bastante con una buena técnica.Developing the pantorouter concept. Son muchas las herramientas de taller que con el tiempo pierden el filo: formones, cepillos manuales y eléctricos, cúter o cuchillas, brocas. Ya hemos visto en otro post cómo afilar brocas con una radial y también con un afilador específico de brocas… Hoy pretendo centrarme en formones y cepillos de carpintero. In addition to the design refinements I have also been able to take advantage of the brief warm spell earlier this week to mill and glue up two sections of the bench top.ElTallerdeCarlos: septiembre 2013. I raised the stretchers by an inch to allow room for a foot to fit underneath. I also added one more lamination to the top to take the depth to just under 24'.
0 Comments
Leave a Reply. |